Extractor bit set for damaged screws including but not confined to hex socket and Phillips heads!
-
Works with 2~5mm (Across Flats) stripped hex socket of cap bolt, countersunk or button head
-
Used manually with 6.35 driver handle or with a power screwdriver
-
Sharp & fine-pitch spiral tip grips a hex socket without slippage.
-
Also useful as an extractor for other screw drives such as Phillips, Torx, etc. if an electric drill is used to make a pilot hole (The process described below.)
-
Comes with a plastic carrying case
-
Bit size : 105mm x Hex. 6.35mm
-
Material : High carbon steel
Specifications
Application to Socket Screws
-
Press the extractor bit into the stripped socket.
-
Twist it out while keeping the bit pressed firmly.
When using a power screwdriver, select slower speed in reverse mode and spin it counterclockwise.
Application to Phillips & other drives
-
Drill a pilot hole in the center of screw head.
-
Select the appropriate size of DBZ-62/63/64/65 (2mm, 3mm, 4mm or 5mm), which corresponds to the pilot hole (the diameter of the drill used).
-
Apply a tip of the extractor and spin it counterclockwise while pressing downward. A power screwdriver can be also used. (slower speed recommended)